Audio Technica PRO35 Cardioid Condenser Clip-On Instrument Microphone
Product Code: PRO35
Features
• Designed for sax, toms, brass and percussion
• Ideal for active stage performances
• UniMount® clip permits accurate positioning
• Cardioid polar pattern reduces pickup of sounds from the sides and rear
Designed for saxophone, brass and percussion, the PRO35 is ideal in applications with high sound pressure levels, and for stage performances. It comes equipped with the UniMount®
clamp, which allows for precise positioning, better impact resistance, and a good protection of the capsule.
- Ideal microphone for sax, toms, brass and percussion
- Cardioid polar pattern improves
isolation of desired sound source and reduces the pickup of sounds to the sides and rear
- Perfect for non-static stage performances
- Extended frequency response renders all the subtle nuances of a
performance
- 80Hz low-cut filter on the power module
- UniMount® clip allows for precise positioning, providing impact resistance and protecting the capsule
- Gold plated
corrosion-resistant contacts on the XLRM-type connectors
- Excels in applications with high sound pressure level |
| Element |
Fixed-charge back plate, permanently polarized condenser |
| Polar Pattern |
Cardioid |
| Frequency Response |
50 - 15,000 Hz |
| Open Circuit Sensitivity |
-45 dB (5.6 mV) re 1V at 1 Pa |
| Impedance |
250 ohms |
| Maximum Input Sound Level |
145 dB SPL, 1 kHz at 1% T.H.D. |
| Low Frequency Roll Off |
80 Hz, 18 dB/octave |
| Switches |
Flat, roll-off |
| Dynamic Range |
115 dB, 1 kHz at Max SPL |
| Signal-to-Noise Ratio |
64 dB, 1 kHz at 1 Pa |
| Phantom Power Requirements |
11-52V DC, 2 mA typical |
| Weight |
111 g |
| Cable |
6.0' (1.8 m) long (permanently attached to microphone), 0.10" (2.6 mm) diameter, 2-conductor, shielded cable with TA3F-type connector |
| Accessories |
AT8418 UniMount® microphone instrument mount; AT8538 power module; soft protective pouch |
|
|
