| DPA d:dicate™ 2006E Twin Diaphragm Omni
Microphone, Active Cable |
|
|
|
2006-ER |
|
Twin Diaphragm Omni Microphone, Rear
Cable |
 |
|
|
2006-ES |
|
Twin Diaphragm Omni Microphone, Side
Cable |
|
|
• Modular
flexibility
• Twin-Diaphragm-Capsule technology
• Acoustic authenticity
• Linear in a large frequency bandwidth
2006E is part of the flexible DPA d:dicate Recording Microphones
series. The 2006E with the MMP-E rear or side active cable offers
an ultra-compact appearance with excellent linear response and high
Radio Frequency Interference rejection.
At any time and with no tools necessary it is possible to transform
the basic 2006E microphone into a new configuration by combining it
with another DPA microphone capsule or preamp.
Twin Diaphragm Capsule technology
The overall distinctive sound image from the DPA miniatures is so
well balanced that it meets the high demands of the DPA d:dicate
league.
In a 2006 capsule two opposite facing miniature capsules are custom
re-built into a double diaphragm, one-capsule composition. This
combines the advantages of small capsules (fast impulse response
and large frequency bandwidth) with lower inherent noise achieved
from a larger diaphragm area.
The capsules are loaded to the supreme d:dicate preamps instead of
the tiny miniature FET preamp from the miniature mics, offering
even more air and precision.
Dedicated to acoustic authenticity
As a suspended main AB stereo pair the 2006E’s offer an
impeccable clean and flat frequency response. With a length of only
3,5 cm, the low-key appearance of the 4006E goes well together with
its modular nature, making it possible to quickly combine the
capsule with another pre-amp or boom pole or choosing another
capsule with the active cable.
|
| Directional pattern: |
Omnidirectional |
| Principle of operation: |
Pressure |
| Cartridge Type: |
Pre-polarized condenser,
Twin Diaphragm Capsule |
| Frequency range: |
20 Hz to 20
kHz |
| Frequency range, ± 2 dB: |
50 Hz to 20 kHz with typ. 3
dB soft boost at 14 kHz |
| Sensitivity, nominal, ± 2 dB at 1 kHz: |
40 mV/Pa; -28 dB re. 1
V/Pa |
| Equivalent noise level, A-weighted: |
Typ. 16 dB(A) re. 20
µPa (max. 18 dB(A)) |
| Equivalent noise level, ITU-R BS.468-4: |
Typ. 28 dB (max. 30
dB) |
| S/N
ratio (A-weighted), re. 1 kHz at 1 Pa (94 dB SPL): |
Typ. 78
dB(A) |
| Total Harmonic Distortion (THD) at 1 kHz: |
< 1 % up to 130 dB SPL
peak |
| Minimum load impedance: |
2 kohm |
| Dynamic range: |
Typ.
116dB |
| Max. SPL, peak before clipping: |
132dB |
| Switchable attenuator: |
-NiL- |
| Output impedance: |
<100
ohm |
| Cable drive capability: |
100 m (328
ft) |
| Output balance principle: |
Impedance
balancing |
| Common Mode Rejection Ratio (CMRR): |
> 40
dB |
| Power supply (for full specifications): |
48 V Phantom power (± 4
V) |
| Current consumption: |
3.5
mA |
| Color: |
Matte
black |
| Weight: |
111 g (3.9
oz) |
| Diameter: |
19 mm (0.75
in) |
| Microphone Length: |
29
mm (1.14
in) |
| Output voltage, RMS: |
2.2V |
| Polarity: |
+V at Pin 2 for positive
sound pressure |
| Temperature range: |
-40 °C to 45 °C
(-40 °F to 113 °F) |
|
Relative Humidity (RH): |
Up to 90% |
| Sensitivity selection tolerance (at 1 kHz): |
+/- 1.5
dB |
|
|
|
|
|
