DPA Microphones has joined forces
with Rycote® to develop the DPA 4017 Shotgun/Rycote®
Windshield Solution. The strong suspension and windshield solution
has been designed specifically to take the DPA 4017B shotgun
mic’s compact size and light weight into consideration.
This kit provides everything an outside broadcaster, journalist or
location film maker could need for clear, directional sound,
regardless of the weather and environmental conditions.
Included in the box
• DPA 4017B Shotgun premounted in Rycote® Suspension
with the Rycote® Windshield
• DPA XLR cable
• DPA Windscreen for 4017B
• Rycote® fur windjammer
• Rycote® XLR holder
• Rycote® brush |
| Directional pattern: |
Supercardioid,
lobe-shaped |
| Principle of operation: |
Pressure gradient, with
interference tube |
| Cartridge Type: |
Pre-polarized
condenser |
| Frequency range: |
20 Hz to 20
kHz |
| Frequency range, ± 2
dB: |
70 Hz to 20 kHz,
permanent third order high pass filter at 50 Hz |
| Sensitivity, nominal, ± 2 dB at 1
kHz: |
19 mV/Pa; -34.4 dB
re. 1 V/Pa |
| Equivalent noise level,
A-weighted: |
Typ. 14 dB(A) re. 20
µPa (max. 15 dB(A)) |
| Equivalent noise level, ITU-R
BS.468-4: |
Typ. 25 dB (max. 26
dB) |
| S/N ratio (A-weighted), re. 1 kHz at 1
Pa (94 dB SPL): |
Typ. 80
dB(A) |
| Total Harmonic Distortion (THD) at 1
kHz: |
< 1 % up to 133 dB
SPL peak |
| Filters: |
High boost: +4 dB at 8
kHz. Low cut: First order filter, below 120 Hz |
| Dynamic range: |
Typ.
119dB |
| Max. SPL, peak before
clipping: |
152
dB |
| Output impedance: |
<150
ohm |
| Cable drive capability: |
100 m (328
ft) |
| Output balance principle: |
Signal
balanced |
| Common Mode Rejection Ratio
(CMRR): |
> 40
dB |
| Power supply (for full
specifications): |
48 V Phantom power
(± 4 V) |
| Current consumption: |
4.5
mA |
| Color: |
Matte
black |
| Weight: |
68 g (2.4
oz) |
| Diameter: |
19 mm (0.75
in) |
| Capsule diameter: |
19 mm (0.75
in) |
| Output voltage, RMS: |
> 1.8
V |
| Microphone Length: |
212 mm (8.3
in) |
| Polarity: |
+V at Pin 2 for
positive sound pressure |
| Connector: |
XLR-3M. Pin 1: shield,
Pin 2: signal + phase, Pin 3: - phase |
|
Relative Humidity
(RH): |
Up to
90% |
| Temperature range: |
-40 °C to 45
°C (-40 °F to 113 °F) |
|
|
|
