|
PSM 700
Wireless Personal Monitor System without Earphones -
P7TR |
|
Product Code: p7tr
|
The PSM®700 series offers advanced controls and
features that make it easy to quickly locate and lock in the
clearest frequency, prevent distortion and minimize the number of
antennas required to send mixes.
|
|
Features |
-
Built-in audio limiter
-
Internal power supply
-
1/2 rack space
-
Remotable/combinable antennas
|
|
Specifications |
- System:
RF Carrier Frequency Range
524 - 865 MHz (Available frequencies vary, depending on applicable
regulations in the country where the system is used)
- Operating Range: 90 m (300 ft.), under optimum environmental
conditions
- Audio Frequency Response: 50 to 15k Hz (+0, 3 dB @1 kHz);
earphone dependent
- Image Rejection: 80 dB typical
- Spurious Rejection: 80 dB typical
- Total Harmonic Distortion (@1 kHz): 0.8% typical (Ref. +/-
35 kHz deviation)
- Modulation: FM +/- 35 kHz deviation (nominal), MPX
Stereo
- Channel Separation: 35 dB typical
- Signal-to-Noise Ratio: 80 dB typical (A-weighted)
- Operating Temperature
7 degrees C to +49 degrees C (+20 degrees F to 120 degrees F)
NOTE: Electrical safety approval is based on a maximum ambient
temperature of 35 degrees C.
- Battery Life: 4 6 hours, volume dependent
- Polarity:
P7T audio inputs to P7R audio outputs: Non-inverting
XLR: pin 2 positive with respect to pin 3
1/4 in TRS: Tip positive with respect to ring
- P7R Wireless Bodypack Receiver:
- RF Sensitivity:0.7 µV typical
- Squelch Threshold: 2 µV typical
- Antenna Input Impedance: 50 ohms typical
- Antenna: External, threaded connector
- Power: 9 V battery (alkaline recommended), 4 6 hours (volume
dependent)
- Audio Output Connector: 3.5 mm Stereo (Left = tip, Right =
ring, Ground = sleeve)
- Minimum Load Impedance: 16 ohms
- Net Weight: 0.23 kg (0.52 lbs.)
- Overall Dimensions: 27.18 mm X 64.52 mm X 85.09 mm (1.070 in
X 2.540 in X 3.350 in)
- P7T Transmitter:
- RF Output Power: 100 mW (+20 dBm) typical conducted, U.S.A.
and Canada (varies with other countries)
- Modulation Limiter: Internal peak limiter (>10:1
compression)
- Antenna: External whip, 50 ohm BNC connector
- Power Requirements
P7T: 90 120 VAC, 50/60 Hz
EP7T: 220 240 VAC, 50/60 Hz
NOTE: This product is not disconnected from the mains power supply
when the power switch is in the OFF position.
- Current
115 mA maximum at 120 VAC
55 mA maximum at 230 VAC
- Fuse
P7T: 90 120 VAC, 160 mA/250 V (SLO-BLO®)
EP7T: 220 240 VAC, 80 mA/250 V time delay 5mm X 20mm
- Dimensions: 44.5 mm X 196.8 mm X 241.3 mm (1 3/4 in X 7 3/4
in X 9 1/2 in.)
- Net Weight: 1.497 kg (3 lb, 4.8 oz.)
|
|
|