SHURE Pro Audio Equipment - Personal Monitor Systems & Earphones PSM400, PSM 400

PSM®400 Wireless and Wired systems make professional quality personal monitoring available to more performers than ever before. Each system includes everything a working musician or band needs to receive consistent personal monitor mixes. Designed for performers who are tired of the limits of floor wedges, the PSM 400 offers hands-on control and freedom to musicians who have a limited budget for gear. With a wide range of available options - from complete Wireless and Wired systems to individual components - there is a PSM 400 that is right, rehearsal through performance, for almost everyone who performs live music.

Features

Attached input cable
High-impact plastic chassis

Specifications

P4HW Wired Bodypack
Frequency Response: 20 to 20,000 Hz
Total Harmonic Distortion: < .1% (measured at 10 dBu out)
Channel Separation: 35 dB (minimum)
Signal-to-noise ratio: 85 dB (minimum)
Maximum Output Level: +5 dBu at 1% THD
Maximum Input Level:
+7 dBu, input pad OFF
+22 dBu, input pad ON
Actual Input Impedance: > 40 kilohms
Audio Output Connector: 3.5 mm stereo (left=tip, right=ring, ground=sleeve)
Power Requirements: 9 V Alkaline battery
Battery Life: Up to 8 hours, volume dependant
Phantom Power Protection: Up to 60 VDC
P4M Personal Monitor Mixer
Measurement Conditions (unless otherwise specified): full gain; 1 kHz, one channel activated; >source impedances: Mic 150 ohms, Aux Level 150 ohms; terminations: Line 600 ohms.
Frequency Response (Ref 1 kHz, controls centered): 20 Hz to 20 kHz +/- 2 dB
Input Specifications

	Input
	1-4 (front panel)	Aux In
Gain (Maximum)	43 dB	0 dB
Impedance (at 1 kHz)	5800 ohms	18 kilohm (each) 9100 ohms (1/L mono)
Input Clipping Level	+12 dBV	+12 dBV
Crosstalk	-100 dB	-90 dB
Common Mode Rejection	> 75 dB	> 70 dB

Output Specifications

	Output
	Split 1-4	Mix Out
Impedance	N/A	500 ohm (unbalanced) 1 kilohm (balanced
Output Clipping Level	N/A	+5 dBV (10 kilohm balanced load, -30 dBV input ch. 1-4)
Noise (100 Hz to 22 kHz)	-110 dBV	-100 dBV (all controls CCW) -62 dBV (all controls CW)
Distortion (THD) at 1 kHz	.0005%	<.05% (0 dBV output)
Crosstalk	-100 dB	-70 dB

LEDs: Resultant Mix Out Level
Green: -30 dBV
Yellow: -10 dBV
Red: 0 dBV
Current: 120 mA max.
Power Requirements:
Operating voltage 14 18 Vdc
Supplied with one of the following external power supplies:

Model PS40: 120 Vac, 60 Hz input

Model PS40E, Model PS40UK: 230 Vac, 50/60 Hz input
NOTE: Courtesy DC connector is protected from short by a self resetting "Polyfuse". Maximum recommended load is 250mA. (2 P4Ms or 1 P4T.)
Phantom Power: The P4M does not produce phantom power, but phantom power is allowed to pass through Split Outputs 1 4 to inputs 1 4 respectively.
Audio Polarity:
All outputs in polarity with all inputs.
XLR Pin 2 is "hot" with respect to Pin 3; Pin 1 is ground.
1/4" TRS tip is "hot" with respect to ring; sleeve is ground.
Temperature Range:
Operating: -7 degrees to 49 degrees C (20 degrees to 120 degrees F)
Storage: -29 degrees to 74 degrees C (-20 degrees to 165 degrees F)
Overall Dimensions: 44 mm H x 218 mm W x 162 mm D (1.72 x 8.60 x 6.37 inches)
Net Weight: 1.20 Kg (2 lbs, 10 oz)

SHURE P4MHWE3 Wired Personal Monitor System

SHURE
P4MHWE3 Wired Personal Monitor System