|
|
| P2T
Wireless TransMixer |
|
|
Product Code: p2t
|
The P2T
TransMixer is breakthrough design for personal monitoring. It
allows the user to connect two line-level or miclevel inputs
directly into the transmitter. The two signals can then be mixed
independently. You can connect microphones or instruments directly
to the inputs, use line outputs from a mixing console, or connect
it to the Shure AuxPander. In short, no matter what the output
device, you can probably plug it into the TransMixer. For use with
PSM 200 monitors. |
|
| Features |
- Built-in audio
limiter
- Front mounted
antenna
- Two mic/line input channels for
mix control
- 1/2 Rack space
|
|
| Specifications |
- RF Output Power; 30 mW (+15 dBm)
typical conducted (country dependent)
- Modulation Limiter: Internal peak
limiter (>10:1 hard knee compression)
- Antenna: 1/4 Wavelength,
semi-rigid, PCB Mount
- P2T Audio Input
- Connector Type: XLR-1/4-inch
combo
- Configuration: electronically
balanced
- Actual Impedance: 1
kilohm
- Nominal Input Level: 25 dBu @ 1/2
volume (12 o'clock)
- Maximum Input Level: 5 dBu @ 1/2
volume (12 o'clock)
- Pin Assignments: XLR: 2=hot;
3=cold, 1=ground
1/4: Tip = hot, Ring = cold, Sleeve=ground
- Phantom Power Protection? Yes: Up
to 52 Vd
- Current: 170 mA maximum
- Dimensions: 220 mm x 140 mm x 40 mm
(8.6 in. x 5.6 in. x 1.7 in.)
- Net Weight: 370 g (13
oz.)
- P2T Audio Outputs
- Passive connection parallel with
input:
- Connector Type: XLR
- Configuration: electronically
balanced
- Pin Assignments: 2 = hot ; 3 =
cold, 1 = ground
- Phantom Power Protection? Yes: Up
to 52 Vdc
- Power Requirements
- Operating voltage 12-18
Vdc
- Supplied with one of the following
external power supplies:
- Model PS20: 120 VAC, 60 Hz
input.
- Model PS20E, Model PS20UK: 230 VAC,
50/60 Hz input.
|
|
|
