| The APS 25-US1 powered speaker system is a fully
self-contained wireless sound reinforcement system with a headset
mic and single UHF wireless bodypack transmitter.
Incorporating a 20 watt amplifier, the APS 25 is a
rugged, 2-way speaker with a 5.25" shielded woofer and a 1"
wide-dispersion tweeter that produces clear detailed sound for all
corporate, educational and commercial
applications.
The APS
25 includes a Master Volume control and Tone control to reduce
feedback. Individual level controls for each of the four inputs-
two wireless, one wired mic level, and one line level-giving you
more ways to configure your system. The speaker's variable line
level output lets you daisy chain multiple speakers. The high gain
mic input shorts automatically to reduce noise when no mic is
plugged in.
Included with the APS 25 is the Auto On-Off
circuitry triggered by any audio input signal for hands-off system
startup; a high impact case for reliability, and
dual-voltage(110/220V) switching to facilitate installation and
use. The speaker can be used free standing, stand-mounted (5/8x27
threaded holes on the bottom and side) or wall-mounted with the
supplied U-mount bracket.
The APS
25-US1 includes a APS-UR UHF receiver module and the 10BT bodypack
with either the HS-11 or HS-12 (choose one below) headset
microphone.
Speaker Technical Specs:
Rated Power: 20 Watts continuous
Frequency Response: 65Hz – 18kHz
Max SPL @ Rated Output: 101db @ 1 meter
Woofer: 5.25" (133.35mm) high efficiency - magnetically
shielded
Tweeter: 1" (25mm) dome
Crossover: 1st order passive @ 8kHz
Tone Control: -6dB/octave sliding low pass (3kHz to
8kHz)
Wireless Inputs: 2 user-installable receivers
VHF (169-213mHz) – 30 fixed frequencies
UHF (794-806mHz) – 63 user-selectable frequencies
Infrared – 2 fixed frequencies
Wired
Inputs/Output:
Mic: -81dBv (0.089mVRMS) for 1 watt, 100K balanced, ¼" phone
jack, variable
Line: -40dBv (10mVRMS) for 1 watt, 10K unbalanced, RCA jack,
variable
Line-Out: +15dBv max - RCA jack
Weight:
8.5lb (3.85kg) approx. w/out receivers
Dimensions: 12.4"H X 7.09"W X 5.6"D (315 X 180 X 142mm)
Compliance: UL, C-UL, and FCC approved
AC Power Requirements: User switchable, 110-125 / 210-240VAC -
50Hz/60Hz
Included w/speaker: Removable wall-mount bracket
with 2 screws, rubber anti-rotate pads, removable right-angle, AC
cord, 4 self-adhesive anti-skid pads, 4 module screws, 1 or 2
noise-canceling circuit boards (depending on how many modules are
installed
Receiver Technical Specs:
Frequency Range: UHF 63-channel Selectable (793.750-805.875MHz)
Oscillator: PLL Synthesized
RF Squelch Level: 14dBµV
Frequency Response: 50Hz - 15kHz
S/N Ratio: better than 90dB (A weighted)
Audio Distortion: <1% @ 1kHz
Operating Temperature Range: 0° - 50° C (32° -
122° F)
Power Requirements: 12V DC @ 120mA
Transmitter Technical Specs:
Frequency Range: UHF 63-Channel Selectable (793.750 -
805.875MHz)
Oscillator: PLL Synthesized
RF Power: 10mW (30mW Max.)
Frequency Response: 50Hz -15kHz
Max Deviation: ±75kHz @ 1kHz Modulation, MIC Input
–11dBm
S/N Ratio: >70dB "A" Weighted
Audio Distortion: <1% @ 1kHz
MIC Sensitivity: ±40kHz @ -22dBm MIC Input (0dBm +0.775V)
Operating Temp: 0°C-50°C (32°F-122°F)
MIC Input Connector: 3.5mm Mini Jack
Power Requirement: 1- 9V Alkaline Battery
Battery Life: 6 - 8 Hours w/Alkaline Battery
Dimensions: 62W x 100H x 22D mm (2.44W x 3.94H x 0.87D inches)
Weight Approx: 120g Including Battery (4.23oz)
|
> AZDEN > AC and Battery Speakers >
APS
25-US1
