|
Video |
|
Gain |
Unity |
|
Bandwidth |
|
|
Composite video 4, 6, and 8
input models |
300 MHz (-3 dB) |
|
S-video models and composite
video 12 input models |
250 MHz (-3 dB) |
|
Crosstalk |
<-60 dB @ 5 MHz |
|
Switching speed |
<20 ms (max.) |
|
Video input |
|
Number/signal type |
|
|
SW 8/12V, SW 4/6/8AV/AV RCA, SW
6/8/12A/A RCA |
4, 6, 8, or 12 (depending on the model)
composite video |
|
SW 6/8/12SV, SW 4/6SVA/SVA RC |
4, 6, 8, or 12 (depending on the model)
S-video |
|
Connectors |
|
|
SW 8/12V, SW 4/6/8AV/AV RCA, SW
6/8/12A/A RCA |
4, 6, 8, or 12 (depending on the model)
female BNC |
|
SW 6/8/12SV, SW 4/6SVA/SVA RC |
4, 6, 8, or 12 (depending on the model)
female 4-pin mini DIN |
|
Nominal level |
1 Vp-p for Y of S-video, and for composite
video
0.3 Vp-p for C of S-video |
|
Minimum/maximum levels |
0.4 V to 2.0 Vp-p with no offset |
|
Impedance |
75 ohms |
|
Return loss |
<-29 dB @ 0 to 10 MHz |
|
DC offset (max. allowable) |
5.0 V |
|
Video output |
|
Number/signal type |
|
|
Composite video models |
2 buffered composite video |
|
S-video models |
1 buffered S-video, 1 buffered composite
video |
|
Connectors |
|
|
Composite video models |
2 female BNC |
|
S-video models |
1 female BNC, 1 female 4-pin mini DIN |
|
Nominal level |
1 Vp-p for Y of S-video, and for composite
video
0.3 Vp-p for C of S-video |
|
Minimum/maximum levels |
0.4 V to 2.0 Vp-p (follows input) |
|
Impedance |
75 ohms |
|
Return loss |
-30 dB @ 5 MHz |
|
DC offset |
�5 mV with input at 0 offset |
|
Switching type |
Vertical interval switching |
|
Sync |
|
Genlock connectors |
2 female BNC (1 input, 1 loop-through) |
|
Standards |
NTSC 3.58, NTSC 4.43, PAL, SECAM |
|
Audio |
|
Gain |
Adjustable. When gain is set to unity (0
dB), balanced output from captive screw connectors or unbalanced output
from RCA connectors has a 0 dB gain; unbalanced output from captive
screw connectors is attenuated by 6 dB. |
|
Frequency response |
20 Hz to 20 kHz, �0.5 dB |
|
THD + Noise |
<0.04% @ 1 kHz at nominal level |
|
S/N |
>90 dB at maximum output (unweighted) |
|
Audio input |
|
Number/signal type |
|
|
SW 4/6/8AV, SW 4/6SVA, SW
6/8/12A |
4, 6, 8, or 12 (depending on the model)
stereo, balanced/unbalanced |
|
SW 4/6AV RCA, SW 4/6SVA RCA, SW
6A RCA |
4, 6, 8, or 12 (depending on the model)
stereo, unbalanced |
|
Connectors |
|
|
SW 4/6/8AV, SW 4/6SVA, SW
6/8/12A |
4, 6, 8, or 12 (depending on the model) 3.5
mm captive screw connectors, 5 pole |
|
SW 4/6AV RCA, SW 4/6SVA RCA, SW
6A RCA |
8, 12, 16, or 24 (depending on the model)
female RCA |
|
Impedance |
|
|
RCA models |
12k ohms unbalanced, DC coupled |
|
All other models |
25k ohms unbalanced, 50k ohms balanced, DC
coupled |
|
Nominal level |
+4 dBu (1.23 Vrms), -10 dBV (316 mVrms),
configurable |
|
Maximum level |
>+15 dBu, (balanced or unbalanced) at 1%
THD+N |
|
Input gain adjustment |
�18 dB to +24 dB, adjustable per input |
| NOTE |
0
dBu = 0.775 Vrms, 0 dBV = 1 Vrms, 0 dBV ≈ 2 dBu.
|
|
|
Audio output |
|
Number/signal type |
|
|
SW 4/6/8AV, SW 4/6SVA, SW
6/8/12A |
2 stereo, balanced/unbalanced |
|
SW 4/6AV RCA, SW 4/6SVA RCA, SW
6A RCA |
1 stereo, unbalanced |
|
Connectors |
|
|
SW 4/6/8AV, SW 4/6SVA, SW
6/8/12A |
(2) 3.5 mm captive screw connectors, 5 pole |
|
SW 4/6AV RCA, SW 4/6SVA RCA, SW
6A RCA |
2 female RCA
(1) 3.5 mm captive screw connector, 5 pole |
|
Impedance |
50 ohms unbalanced, 100 ohms balanced |
|
Gain error |
�0.1 dB channel to channel |
|
Nominal level |
+4 dBu (1.23 Vrms), -10 dBV (316 mVrms),
configurable |
|
Maximum level (Hi-Z) |
>26 dBu, balanced; >+20 dBu, unbalanced at
1% THD+N |
|
Maximum level (600 ohm) |
>21 dBm, balanced; >+15 dBm, unbalanced at
1% THD+N |
|
Control/remote � switcher |
|
Serial control port |
RS-232, female 9-pin D connector (also used
for contact closure for 4- and 6-input models) |
|
Baud rate and protocol |
9600 baud, 8 data bits, 1 stop bit, no
parity |
|
Serial control pin configuration |
2 = Tx, 3 = Rx, 5 = GND |
|
Contact closure (SW 4 and 6 models
only) |
1 female 9-pin D connector (also used for
RS-232) |
|
Contact closure pin configuration
(SW 4 and 6 models only) |
1 = input 1, 4 = input 2, 5 = GND, 6 = input
3, 7 = input 4, 8 = input 5, 9 = input 6 |
|
IR controller module |
Extron IR 102 kit (optional) |
|
Program control |
Extron control/configuration program for
Windows�
Extron Simple Instruction Set (SIS�) |
|
General |
|
Power supply |
Internal
Input: 100-240 VAC, 50-60 Hz |
|
Temperature/humidity |
Storage: -40 to +158 �F (-40 to +70 �C) /
10% to 90%, noncondensing
Operating: +32 to +122 �F (0 to +50 �C) / 10% to 90%, noncondensing |
|
Cooling |
Convection, no vents |
|
Mounting |
|
|
Rack mount |
Yes, with included rack mounting kit |
|
Furniture mount |
Yes, with optional under-desk mounting kit |
|
Enclosure type |
Metal |
|
Enclosure dimensions |
1.75" H x 17.4" W x 8.5" D (1U high, full
rack wide)
4.4 cm H x 44.2 cm W x 21.6 cm D
(Depth excludes connectors.) |
|
Product weight |
7.0 lbs (3.2 kg) |
|
Shipping weight |
10 lbs (5 kg) |
|
Vibration |
ISTA 1A in carton (International Safe
Transit Association) |
|
Regulatory compliance |
|
|
Safety |
CE, c-UL, UL |
|
EMI/EMC |
CE, C-tick, FCC Class A, ICES, VCCI |
|
Warranty |
3 years parts and labor |
