DPA d:dicate� ST2006A Stereo Pair with 2006A Omnis
|
|
Product Code:
ST2006A
 |
� Sensitivity selected pair
� Acoustic authenticity
� Linear in a large frequency bandwidth
� PeliTM Case transportation and protection
The DPA ST2006A is a complete DPA 2006A Stereo Pair with two handpicked omni
microphones, selected on sensitivity within �1.5 dB.
As main AB stereo pair the 2006As deliver precise acoustic fingerprint and true
tone. Orchestra, acoustic piano, guitar, wind instruments and choirs are among
the most evident applications for this high-value-for-money pair.
The foam design in the heavy-duty transportation box allows for fast and easy
exchange of microphone and accessory inlays.
Included in this kit
Two carefully matched 2006A omni microphones, sturdy PeliTM case, holders, and
windscreens. |
|
Directional
characteristics: |
Omnidirectional |
|
Principle of
operation: |
Pressure |
|
Cartridge type: |
Pre-polarized condenser, Twin Diaphragm Capsule |
|
Frequency range: |
20 Hz - 20 kHz |
|
Frequency
range,
± 2 dB: |
50 Hz - 20 kHz with
typ. 3 dB soft boost at 14 kHz |
|
Sensitivity, nominal+/- 2 dB at 1KHz: |
40 mV/Pa; -28 dB re.
1 V/Pa |
|
Equivalent
noise level A-weighted: |
Typ. 16 dB(A) re. 20
�Pa (max. 18 dB(A)) |
|
Equiv. noise level ITU-R
BS.468-4: |
Typ. 28 dB (max. 30
dB) |
|
S/N ratio (A-weighted), re. 1 kHz at 1 Pa (94 dB SPL): |
Typ. 78 dB(A) |
|
Total harmonic distortion
(THD): |
<1% up tp
130 dB SPL peak |
|
Minimum load impedance: |
2 kohm |
|
Dynamic
range: |
Typ. 114 dB |
|
Max. SPL, peak before
clipping: |
141 dB |
|
Output
impedance: |
<200 ohm |
|
Output balance principle: |
Impedance balancing
with Active Drive |
|
Cable drive
capability: |
100 m (328 ft) |
|
Common Mode Rejection Ratio (CMRR): |
> 60 dB |
|
Power
supply: |
48 V Phantom power (� 4 V) |
|
Current consumption: |
2.8 mA |
|
Connector: |
XLR-3M. Pin 1:
shield, Pin 2: signal + phase, Pin 3: - phase |
|
Color: |
Matte black |
|
Weight: |
160 g (5.6 oz) |
|
Diameter: |
19 mm (0.75 in) |
|
Length: |
164 mm (6.5 in) |
|
Output voltage, RMS: |
> 5 V |
|
Polarity: |
+V at Pin 2 for
positive sound pressure |
|
Operating temperature
range: |
-40 �C to 45 �C (-40
�F to 113 �F) |
|
Relative Humidity (RH): |
Up to 90 % |
|
Sensitivity selection tolerance (at 1 kHz): |
� 1.5 dB |
|
|
|
|
|
