|
|
|
|
|
| |
|
AZDEN APS
25-VL2 Powered Speaker System
|
|
Discontinued
|
The APS 25-VL2 powered
speaker system is a fully self-contained wireless sound
reinforcement system with two VHF wireless bodypack
transmitters.
Incorporating a 20 watt amplifier, the APS 25 is a rugged, 2-way
speaker with a 5.25" shielded woofer and a 1" wide-dispersion
tweeter that produces clear detailed sound for all corporate,
educational and commercial applications.
The APS 25 includes a Master Volume control and Tone control to
reduce feedback. Individual level controls for each of the four
inputs- two wireless, one wired mic level, and one line
level-giving you more ways to configure your system. The speaker's
variable line level output lets you daisy chain multiple speakers.
The high gain mic input shorts automatically to reduce noise when
no mic is plugged in.
Included with the APS 25 is the Auto On-Off circuitry triggered by
any audio input signal for hands-off system startup; a high impact
case for reliability, and dual-voltage(110/220V) switching to
facilitate installation and use. The speaker can be used free
standing, stand-mounted (5/8x27 threaded holes on the bottom and
side) or wall-mounted with the supplied U-mount bracket.
The APS 25-VL2 includes two APS-VR VHF receiver modules (choose
from 25 frequencies below) and two of the 31LT bodypacks with the
EX-503 lavalier microphones.
Speaker Technical
Specs:
Rated Power: 20 Watts continuous
Frequency Response: 65Hz – 18kHz
Max SPL @ Rated Output: 101db @ 1 meter
Woofer: 5.25" (133.35mm) high efficiency - magnetically
shielded
Tweeter: 1" (25mm) dome
Crossover: 1st order passive @ 8kHz
Tone Control: -6dB/octave sliding low pass (3kHz to 8kHz)
Wireless Inputs: 2 user-installable receivers
VHF (169-213 MHz) – 30 fixed frequencies
UHF (566.25-589.75 MHz) – 92 user-selectable frequencies
Infrared – 2 fixed frequencies
Wired Inputs/Output:
Mic: -81dBv (0.089mVRMS) for 1 watt, 100K balanced, ¼" phone
jack, variable
Line: -40dBv (10mVRMS) for 1 watt, 10K unbalanced, RCA jack,
variable
Line-Out: +15dBv max - RCA jack
Weight: 8.5lb (3.85kg) approx. w/out receivers
Dimensions: 12.4"H X 7.09"W X 5.6"D (315 X 180 X 142mm)
Compliance: UL, C-UL, and FCC approved
AC Power Requirements: User switchable, 110-125 / 210-240VAC -
50Hz/60Hz
Included w/speaker: Removable wall-mount bracket with 2 screws,
rubber anti-rotate pads, removable right-angle, AC cord, 4
self-adhesive anti-skid pads, 4 module screws, 1 or 2
noise-canceling circuit boards (depending on how many modules are
installed
Receiver Technical
Specs:
Frequency Range: 25 VHF channels (169.505-195.975MHz)
Frequency Response: 40Hz - 18kHz
S/N Ratio: better than 95dB (A weighted)
Operating Temperature Range: 0 - 45 C (32 - 113 F)
Operating Range: approx 100m (ideal-line of sight)
Oscillator: Crystal Controlled
Receiver Type: Super Heterodyne
Image Rejection: Better than 60dB
RF Sensitivity: -95dBm @ 50dB S/N
Audio Output Impedance: 2.2k ohms
Power Requirements: 10 - 16VDC
Transmitter Technical
Specs:
Frequency Range: 25 VHF Channels
(169.505 - 197.325 MHz) Frequency Response: 40Hz to 18KHz
(+/- 3dB) Audio Distortion: less than 1.0% (± 15K
deviation)
Dynamic Range: better than 100dB
S/N Ratio: better than 95dB
Operating Temperatures: 0° C to 45° C
Operating Range: 100m under ideal conditions
Oscillator: Crystal Controlled
Type of Emission: FM
Antenna: External Antenna
Pre-emphasis: 50 Micro Sec.
MAX Input Level: 0dBm - 10dBm
Microphone: Lav. or Headset
RF Output Power: 30mW
Input Impedance: 2.2 k ohms
Audio Adj. Range: +30dB
Battery: 9v (006p)
Battery Life: 8 to 10 hours with Alkaline Battery
Dimensions: 86(H) x 60(W) x 21.5(D) mm (3.4" x 2.4" x 0.85")
Weight: 112g (Without Battery, Mic, Cable) - (3.9
oz) |
 |
|
| |
|
> AZDEN > AC and Battery Speakers > APS
25-VL2
