|
P2TRE2
Wireless Personal Monitor System |
|
Product Code: p2tre2
|
Whether you're
playing live or rehearsing, you need to hear yourself to be your
best. That's what monitoring is all about. Yet some performers
still struggle with booming floor wedge monitors and loud stage
volume. Introducing the PSM®200 - the personal monitoring
break through that performers have been waiting for. Featuring
smart, versatile components that grow with you as your needs
change, the PSM 200 series is a practical alternative to floor
wedges for performers who want to start out In Ear and stay
there.
The P2R Hybrid Bodypack Receiver is the world's first
bodypack receiver to function as a wired receiver, a wireless
receiver, or both at the same time. This and other unique features,
along with excellent sound quality, make the P2R an exceptional
value.
The P2T Wireless TransMixer is another breakthrough
design for personal monitoring. It allows the user to connect two
line-level or mic–level inputs directly into the transmitter.
The two signals can then be mixed independently. You can connect
microphones or instruments directly to the inputs, or use line
outputs from a mixing console. In short, no matter what the
output device, you can probably plug it into the TransMixer.
The PSM 200 model P2TRE2 wireless personal monitor system with mix
control consists of the P2T Wireless TransMixer, the P2R Hybrid
Bodypack Receiver, and clear SCL2 Sound
Isolating Earphones.
|
|
Features |
- Built-in audio
limiter
- Front mounted
antenna
- Two mic/line input channels for
mix control
- 1/2 Rack space
- Can operate as a wired or
wireless bodypack, or both simulaneously
- Frequency
locator
- Built-in headphone
limiter
- Integrated cable
management
- High-impact plastic
chassis
- 1/4" Line inpit jack with
high/low gain switch
|
|
Specifications |
- PSM®200
System
- RF Carrier Frequency Range: 518
-865 MHz (country dependent)
- Operating Range: 100 m (300 ft.)
under optimal conditions
- Audio Frequency Response: 30 Hz
to 12 kHz (+/ 3 dB); earphone dependent
- Total Harmonic Distortion (1
kHz): <1% typical (Ref. +/- 35 kHz deviation)
- Modulation: FM +/- 35 kHz
Deviation (Nominal)
- Signal-to-Noise Ratio: 80 dB
typical (A-weighted)
- Operating Temperature: -7
degrees C to +49 degrees C (+20 degrees F to +120 degrees
F)
- P2T
TransMixer
- RF Output Power: 30 mW (+15 dBm)
typical conducted (country dependent)
- Modulation Limiter: Internal
peak limiter (>10:1 hard knee compression)
- Antenna: 1/4 Wavelength,
semi-rigid, PCB Mount
- P2T Audio Input
- Connector Type: XLR/1/4-inch
combo
- Configuration: electronically
balanced
- Actual Impedance: 1
kilohm
- Nominal Input Level: 25 dBu @
1/2 volume (12 o'clock)
- Maximum Input Level: 5 dBu @ 1/2
volume (12 o'clock)
- Pin Assignments: XLR: 2=hot;
3=cold, 1=ground
1/4: Tip = hot, Ring = cold, Sleeve=ground
- Phantom Power Protection? Yes:
Up to 52 Vdc
- Current: 170 mA
maximum
- Dimensions: 220 mm x 140 mm x 40
mm (8.6 in. x 5.6 in. x 1.7 in.)
- Net Weight: 370 g (13
oz.)
- P2T Audio Outputs Passive
connection parallel with input.
- Connector Type:
XLR
- Configuration: electronically
balanced
- Pin Assignments: 2 = hot ; 3 =
cold, 1 = ground
- Phantom Power Protection? Yes:
Up to 52 Vdc
- Power
Requirements
- Operating voltage 12-18
Vdc
- Supplied with one of the
following external power supplies:
- Model PS20: 120 VAC, 60 Hz
input.
- Model PS20E, Model PS20UK: 230
VAC, 50/60 Hz input.
- P2R
Receiver
- RF Sensitivity: 109 dBm
typical
- Squelch Threshold: 102 dBm
typical
- Antenna: Attached
Whip
- Audio Input
Connector
- Connector Type: 1/4-inch
Mono
- Impedance: 1
megohm
- Maximum Input Level: LO = +0
dBu; HI = 10 dBu
- Frequency Response: 30 Hz to 20
kHz (+/ 3 dB); earphone dependent
- Power Requirements: 9 V alkaline
battery, Duracell® type MN1604 recommended
- Battery Life: Volume
Dependent
- Wired (RF Off): 6
hours
- Wireless (RF On): 4
hours
- Audio Output Connector: 1/8 inch
(3.5 mm)
- Minimum Load Impedance: 8
ohms
- Net Weight: 100 g (3.52 oz.),
less battery
- Overall Dimensions: 122 mm x 73
mm x 32 mm (4.809 in. x 2.875 in. x 1.251 in.)
|
|
|