|
DPA d:dicate� MMP-B
Preamp, low cut and high boost |
|
Product Code:
MMPB
|
Preamplifier
with low cut and high boost filters.
Combine this preamp with any capsule in the DPA d:dicate Recording Microphones
series. |
|
Output
connector: |
XLR-3M. Pin 1: shield, Pin 2:
signal + phase, Pin 3: - phase |
|
Low-cut frequency, -3 dB: |
50
Hz |
|
Noise
with shorted input, A-weighted: |
1.1 µV |
|
Output voltage, RMS: |
> 1.8
V |
|
Output
voltage, peak: |
> 2.5 V |
|
Type of electronic circuit: |
Active |
|
THD@1VRMS, 1kHz: |
< 0.5 % |
|
Dynamic range: |
124
dB |
|
Switchable attenuator: |
0 dB, -20 dB |
|
Output impedance: |
< 150
ohm |
|
Output balance
principle: |
Signal
balanced |
|
Common Mode
Rejection Ratio (CMRR): |
> 40
dB |
|
Power supply (for full
specifications): |
48 V Phantom power (± 4
V) |
|
Current
consumption: |
4.5
mA |
|
Temperature
range: |
-40 °C to 45 °C (-40
°F to 113 °F) |
|
Color: |
Matte
black |
|
Weight: |
38 g (1.3 oz) |
|
Diameter: |
19 mm (0.75
in) |
|
Microphone Length: |
99 mm (3.9
in) |
|
Relative Humidity (RH): |
Up to
90% |
|
Cable drive capability: |
100 m (328
ft) |
|
Switchable
filters: |
High
boost: +4 dB at 8 kHz. Low cut: First order filter, below 120
Hz |
|
|
|
|
|
