-
Transducer Type: Condenser (electret bias)
-
Polar
Pattern :Cardioid
-
Output
Impedance :150 ohms at 1 kHz, Recommended minimum load impedance:
600 Ohms
-
Sensitivity (at 1,000 Hz) Open Circuit Voltage -50 dBV/Pa
(3.15mV) 1 pa = 94 dB SPL
-
Output Clipping level :1000 Ohm Load at 1,000 Hz:
+3 dBV (1.41 V)
-
Maximum SPL
(at 1,000 Hz) :1000 ohm load (1% THD): 147 dB
-
Self- Noise
: 23 dB typical, A-weighted
-
Dynamic
Range (1000 ohms) :124 dB (maximum SPL to A-weighted noise
level)
-
Signal-to-Noise Ratio:71 dB at 94 dB SPL (IEC
651)*
*S/N ratio is difference between 94 dB SPL and equivalent SPL of
self-noise A-weighted.
-
Polarity:
Positive pressure on diaphragm produces positive voltage on pin 2
relative to pin 3 of the output connector.
-
Power:
Phantom Supply Requirement: 11 to 52 Vdc, positive at both pins 2
and 3 . Current Drain: 5.2 mA.
-
Connector:
Three-pin (XLR) professional audio
-
Case: Dark
gray enamel-painted steel with matte-finished silver colored steel
grille
-
Net Weight:
Net: 278 grams (9.8 oz)
-
Environmental Conditions
Operating: -18 degrees to 60 degrees C (0 degrees to 135 degrees F)
(relative humidity >90%)
Storage: -29 degrees to 74 degrees C (-20 degrees to 165 degrees F)
(relative humidity >80%)
