Audio Technica PRO70 Cardioid Condenser Lavalier/Instrument Microphone

Audio Technica PRO 70
Audio Technica PRO 70   

Audio Technica PRO70 Cardioid Condenser Lavalier/Instrument Microphone

Product Code: PRO70

Buy Sell Sales Audio Technica PRO70


Features

  • Ideal for both vocal and acoustic guitar applications
  • Natural and articulate vocal reproduction
  • Excels in pickup of acoustic guitar
  • Cardioid polar pattern reduces pickup of sounds from the sides and rear
  • Switchable low-frequency roll-off
  • Operates on battery or phantom power

This miniature condenser microphone achieves full-sounding pickup and is known for outstanding consistency and dependable performance. Supplied with both a clothing clip and guitar mount, it provides natural and articulate vocal reproduction when used as a clip-on lavalier and excels in pickup of acoustic guitar. The PRO70 is designed to make music and speech clearly and comfortably audible, yet never draw attention to itself or its operation. The microphone is equipped with a low-frequency roll-off switch that allows for reduced pickup of room noise. The versatile PRO70 may be powered by either battery or phantom power. Its cardioid polar pattern reduces pickup of sounds from the sides and rear, improving isolation of the desired sound source. 

Element  Fixed-charge back plate, permanently polarized condenser 
Polar Pattern Cardioid
Frequency Response 100 - 14,000 Hz
Open Circuit Sensitivity Phantom: -45 dB (5.6 mV) re 1V at 1 Pa Battery: -45 dB (5.6 mV) re 1V at 1 Pa
Impedance Phantom: 200 ohms Battery: 200 ohms
Maximum Input Sound Level Phantom: 123 dB SPL, 1 kHz at 1% T.H.D. Battery: 123 dB SPL, 1 kHz at 1% T.H.D.
Low Frequency Roll Off  80 Hz, 12dB/ocatave 
Switches  Off, on-flat, on-roll-off 
Dynamic Range Phantom: 96 dB, 1 kHz at Max SPL Battery: 96 dB, 1 kHz at Max SPL
Signal-to-Noise Ratio 67 dB, 1 kHz at 1 Pa
Phantom Power Requirements 11-52V DC, 2 mA typical
Battery Type  1.5V AA/UM3 
Battery Life  0.4 mA / 1200 hours typical (alkaline)
Weight 8 g / 134 g (Power module)
Dimensions  21mm (long) ; Ø body 10.2mm 
Output Connector  Integral 3-pin XLRM-type 
Cable  Integral 6' (1.8 m), permanently attached between microphone and power module 
Accessories AT8411 clothing clip; AT8444 instrument adapter; power module; windscreen; battery; soft protective pouch