Audio Technica PRO35 Cardioid Condenser Clip-On Instrument Microphone

Audio Technica PRO35
Audio Technica PRO 35   

Audio Technica PRO35 Cardioid Condenser Clip-On Instrument Microphone

Product Code: PRO35

Buy Sell Sales Audio Technica PRO35


Features

  • Designed for sax, toms, brass and percussion
  • Ideal for active stage performances
  • UniMount® clip permits accurate positioning
  • Cardioid polar pattern reduces pickup of sounds from the sides and rear

Designed for saxophone, brass and percussion, the PRO35 is ideal in applications with high sound pressure levels, and for stage performances. It comes equipped with the UniMount® clamp, which allows for precise positioning, better impact resistance, and a good protection of the capsule.

- Ideal microphone for sax, toms, brass and percussion
- Cardioid polar pattern improves isolation of desired sound source and reduces the pickup of sounds to the sides and rear
- Perfect for non-static stage performances
- Extended frequency response renders all the subtle nuances of a performance
- 80Hz low-cut filter on the power module
- UniMount® clip allows for precise positioning, providing impact resistance and protecting the capsule
- Gold plated corrosion-resistant contacts on the XLRM-type connectors
- Excels in applications with high sound pressure level

Element  Fixed-charge back plate, permanently polarized condenser 
Polar Pattern Cardioid
Frequency Response 50 - 15,000 Hz
Open Circuit Sensitivity -45 dB (5.6 mV) re 1V at 1 Pa
Impedance 250 ohms
Maximum Input Sound Level 145 dB SPL, 1 kHz at 1% T.H.D.
Low Frequency Roll Off  80 Hz, 18 dB/octave
Switches Flat, roll-off
Dynamic Range 115  dB, 1 kHz at Max SPL
Signal-to-Noise Ratio 64 dB, 1 kHz at 1 Pa
Phantom Power Requirements 11-52V DC, 2 mA typical
Weight 111 g
Cable 6.0' (1.8 m) long (permanently attached to microphone), 0.10" (2.6 mm) diameter, 2-conductor, shielded cable with TA3F-type connector
Accessories AT8418 UniMount® microphone instrument mount; AT8538 power module; soft protective pouch