AZDEN APS 25-VH1


	AZDEN APS 25-VH1 Powered Speaker System

	The APS 25-VH1 powered speaker system is a fully self-contained wireless sound reinforcement system with a single VHF wireless handheld microphone and transmitter combination. Incorporating a 20 watt amplifier, the APS 25 is a rugged, 2-way speaker with a 5.25" shielded woofer and a 1" wide-dispersion tweeter that produces clear detailed sound for all corporate, educational and commercial applications. The APS 25 includes a Master Volume control and Tone control to reduce feedback. Individual level controls for each of the four inputs- two wireless, one wired mic level, and one line level-giving you more ways to configure your system. The speaker's variable line level output lets you daisy chain multiple speakers. The high gain mic input shorts automatically to reduce noise when no mic is plugged in. Included with the APS 25 is the Auto On-Off circuitry triggered by any audio input signal for hands-off system startup; a high impact case for reliability, and dual-voltage(110/220V) switching to facilitate installation and use. The speaker can be used free standing, stand-mounted (5/8x27 threaded holes on the bottom and side) or wall-mounted with the supplied U-mount bracket. The APS 25-VH1 includes a APS-VR VHF receiver module (choose from 25 frequencies below) and the 31HT microphone/transmitter Speaker Technical Specs: Rated Power: 20 Watts continuous Frequency Response: 65Hz – 18kHz Max SPL @ Rated Output: 101db @ 1 meter Woofer: 5.25" (133.35mm) high efficiency - magnetically shielded Tweeter: 1" (25mm) dome Crossover: 1st order passive @ 8kHz Tone Control: -6dB/octave sliding low pass (3kHz to 8kHz) Wireless Inputs: 2 user-installable receivers VHF (169-213 MHz) – 30 fixed frequencies UHF (566.25-589.75 MHz) – 92 user-selectable frequencies Infrared – 2 fixed frequencies Wired Inputs/Output: Mic: -81dBv (0.089mVRMS) for 1 watt, 100K balanced, ¼" phone jack, variable Line: -40dBv (10mVRMS) for 1 watt, 10K unbalanced, RCA jack, variable Line-Out: +15dBv max - RCA jack Weight: 8.5lb (3.85kg) approx. w/out receivers Dimensions: 12.4"H X 7.09"W X 5.6"D (315 X 180 X 142mm) Compliance: UL, C-UL, and FCC approved AC Power Requirements: User switchable, 110-125 / 210-240VAC - 50Hz/60Hz Included w/speaker: Removable wall-mount bracket with 2 screws, rubber anti-rotate pads, removable right-angle, AC cord, 4 self-adhesive anti-skid pads, 4 module screws, 1 or 2 noise-canceling circuit boards (depending on how many modules are installed Receiver Technical Specs: Frequency Range: 25 VHF channels (169.505-195.975MHz) Frequency Response: 40Hz - 18kHz S/N Ratio: better than 95dB (A weighted) Operating Temperature Range: 0 - 45 C (32 - 113 F) Operating Range: approx 100m (ideal-line of sight) Oscillator: Crystal Controlled Receiver Type: Super Heterodyne Image Rejection: Better than 60dB RF Sensitivity: -95dBm @ 50dB S/N Audio Output Impedance: 2.2k ohms Power Requirements: 10 - 16VDC Transmitter Technical Specs: Frequency Range: 25 VHF Channels (169.505 - 197.325 MHz) Frequency Response: 40Hz to 18KHz (+/- 3dB) Audio Distortion: less than 1.0% (± 15K deviation) Dynamic Range: better than 100dB S/N Ratio: better than 95dB Operating Temperatures: 0° C to 45° C Operating Range: 100m under ideal conditions Oscillator: Crystal Controlled Type of Emission: FM Antenna: Internal Antenna Microphone Unit: Unidirectional Dynamic RF Output Power: 10mW Input Impedance: 8 ohms Audio Adj. Range: n/a Battery: 1 (AA) Battery Life: 8 to 10 Hours with Alkaline Battery Dimensions: 62mm(ø) 221mm(L) - (2.4" x 8.3") Weight: 213g (7.5 oz) Without Battery