Tempest TMP-B209 900MHz 2-Channel Base Station

tempest TMP-B209 2-Channel Base Station
tempest900 TMP-B209   

Tempest900 2-Channel Base Station

Product Code: TMP-B209

Tempest900 900MHz 2-Channel Base Station


Features

  • 900MHz license free operation
  • Frequency Hopping Spread Spectrum technology
  • Supports up to 5 full duplex BeltStations per Base
  • Three Modes of Operation: Normal, Shared, and Split iSelect™ On Command Roaming
  • 2 communication channels (conversations)
  • Mixed 2-wire and 4-wire operation
  • Compatible with Clear-Com®, RTS®, AudioCom®
  • Hardwired Mic Kill and Call compatible
  • Stage Announce output with relay closures
  • Remote Transceiver port for remote antennas
  • 5 individually assignable relay closures
  • LAN interface for remote monitoring and control
  • Either AC and/or DC (battery) operation

The Tempest900 2-Channel BaseStation is a Frequency Hopping Spread Spectrum (FHSS) digital wireless intercom system operating in the 902 to 928 MHz band ensuring comprehensive coverage and wide reach while offering high resistance to multi-path interference. The front panel LCD display provides real time status including battery monitoring of active BeltStations and easy access to the hardwire intercom settings and levels. Each BaseStation is capable of Call and Remote Mic Kill.

PERFORMANCE
The Tempest900 BaseStation is supplied with a single omni-directional antenna (RP-TNC RF connector). On the rear is a RJ45 connector for a (optional) Remote Transceiver. The Remote Transceiver can be located up to 1500ft (450m) away from the BaseStation over CAT-5/6 cable with no loss of RF signal. The CAT-5/6 cable also supplies power t+Y39o the remote transceiver. An additional RJ-45 enables remote monitoring and control of the entire wireless system over a Local Area Network (LAN) with the aid of the Tempest T-Desk software.

VERSATILITY
The Tempest900 BaseStation connections include a 2-wire or 4-wire interface with M/F 3-pin XLR loop thru and one 4-wire RJ45 port per channel. The 2-wire interface is compatible with Clear-Com®, RTS®, and Telex® intercom systems, and includes an auto-null circuit.

MODES
Three modes of operation are available within each Tempest BaseStation: Normal, Shared, and Split. This feature allows from 5 users to hundreds of users depending on configuration.

EXPANDABILITY
Utilizing the Tempest system TDMA technology and proprietary Accu-Sync synchronization, up to (5) 900 BaseStations and 25 full-duplex wireless BeltStations (in Normal Mode) can be used simultaneously. By switching to Shared or Split Mode, an unlimited number of BeltStations can be registered to each BaseStation using shared resources.

iiSelect ROAMING
The Tempest900 BaseStations handle work zone transitions with iSelect on-command roaming technology. Accessing iSelect through the 900 BeltStation LCD user interface allows a user to easily change their association with another BaseStation location in just a few seconds.

System Specifiations
RF Frequency     902 to 928 MHz
RF Scheme FHSS with TDMA
Effective Radiated Power 250mW using 2dBi antenna
Receiver Sensitivity -100 dBm for 10-5 BER
Radio Certification FCC Part 15, Canadian RSS-210, license free
Transmission Range 1,000 ft. (304.8 m) under ideal conditions. 500 ft. to 900 ft. (152.4 m to 274.3 m) typical
Audio Dynamic Range >94 dB
Audio Frequency Response 300Hz–3.8KHz with proprietary audio voice shaping
System Latency Less than 60 ms direct
Base Station Specifications
Intercom Audio Channels 2
Shared BeltStations per Base Unlimited  
Full Duplex BeltStations per BaseStation 5
Number of Antenna Ports per BaseStation 1
Antenna Connector Type RP-TNC
Number of Synchronized BaseStations           3–5
Maximum Range of BaseSync Cable 3,000 ft (914.4 m)
BaseStation/BeltStation Pairing Via supplied Mini-jack/cable
Programming Port USB
Stage Announce and GPO Closures 6 relays via DA-15
2-Wire Intercom Interface 2 channels via XLR 3F with XLR 3M loop thru
2-Wire Intercom Compatibility           Clear Com, RTS, and Balanced compatible
4-Wire/Matrix Connection 2 ports via RJ-45
Aux Input  ¼“ 3 conductor jack accepts -15.5 to +4 dB, balanced, transformer isolated
Aux Output ¼“ 3 conductor jack nominal -12 to +8 dB, balanced, transformer isolated
Stage Announce Output XLR 3M, nominal -12 to +8 dB, balanced, Transformer isolated
Headset Connector 4-pin male XLR (front panel)
Microphone Type Dynamic or Electret, auto-selected
LCD Display     240 × 64 resolution, 32 level gray scale
Dimensions 1 RU unit, H 1.75 in. × W 19.0 in. × D 12 in. (44.5 mm × 482.6 mm × 304.8 mm)
Weight 10.5 lbs (4.76 kg)
Power Input AC: 85–264 VAC at 50–60 Hertz, 15 Watts DC: Battery 11–32 VDC, 12 Watts
Operating Environment -20° to 50° C (-4° to 122° F); 10% to 90% Humidity
  • Power Cord
  • Antenna (x1)
  • USB A to B Cable
  • USB A to Mini B Cable
  • 1/8' Mini to 1/8' Mini Stereo Cable
  • DB-9 Sync Cable
  • Quick Start Guide
  • Safety